Canon LV-7275 EN - Manual (Page 71)

6
. Usng On-Screen Menu
[Input sgnal select]
Selectng Sgnal Format
[Computer 1], [Computer 2 (Analog)]
Allows you to choose [Computer 1] or [Computer 2 (Analog)] for an RGB source such as a computer, or [COM-
PONENT] for a component video source such as a DVD player. Normally select [RGB/COMPONENT] and the
projector automatically detects a component signal. However there may be some component signals that the
projector is unable to detect. If this is the case, select [COMPONENT].
[VIDEO & S-VIDEO System Select]
This feature enables you to select composite video standards automatically or manually.
Normally select [Auto] and the projector will automatically detect the video standard.
In the case where the projector has difficulty detecting the video standard, select the appropriate video stan-
dard from the menu.
This must be done for VIDEO and S-VIDEO respectively.
Enablng or Dsablng WXGA Mode [WXGA mode]
Selecting [On] will give priority to a WXGA (1280 x 768) signal in recognizing an input signal.
When [WXGA mode] is set to [On], an XGA (1024 x 768) signal may not be recognized on LV-7375, LV-7370 or
LV-7275. In this case, select [Off].
Enablng the denterlace [Progressve]
Turns on or off the deinterlace function for a telecine signal.
Off ......................... Select this option if there is any jitter or artifacts in video.
On .......................... Default standard setting.
NOTE: This feature is not available for RGB and HDTV signals.
Enablng Key Sound and Error Sound [Beep]
This feature turns on or off the keypad sound or alarm when a button on the cabinet and the remote control is
pressed or an error occurs.
[Options (2)]
Settng Off Tmer [Off tmer]
You can use the Off Timer feature to turn off the projector automatically at a preset time.
Eight preset times can be selected:Off, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00 and 16:00.
Selectng Power-savng n [Standby mode]
The projector has two standby modes: [Normal] and [Power-saving].
The Power-saving mode is the mode that allows you to put the projector in the power-saving condition which con-
sumes less power than the Normal mode. The projector is preset for Normal mode at the factory.