Canon LV-7275 EN - Manual (Page 72)

6
. Usng On-Screen Menu
Normal .................. Power indicator: Orange light/STATUS indicator: Green light
Power-saving ........ Power indicator: Orange light/STATUS indicator: Off
The following connectors, buttons or functions will not work during this mode.
- SERVICE PORT, MONITOR OUT connector, and AUDIO OUT connector
- LAN, Mail Alert, AUTO POWER ON(COMP1) functions
- Buttons other than POWER button on the cabinet
- Buttons other than POWER button on the remote control
NOTE: Your setting will not be affected even when [Reset] is done from the menu.
Enablng Drect Power ON [Drect power on (AC)]
Turns the projector on automatically when AC power is supplied. This eliminates the need to always use the POW-
ER button on the remote control or projector cabinet.
Turnng On the Projector By Applyng Computer Sgnal [Drect power on (Comp)]
When the projector is in Standby mode, applying a computer signal from a computer connected to the ANALOG
IN-1 input will power on the projector and simultaneously project the computer’s image.
This functionality eliminates the need to always use the POWER button on the remote control or the projector
cabinet to power on the projector.
To use this function, first connect a computer to the projector and the projector to an active AC input.
NOTE:
• Disconnecting a computer signal from the computer will not power off the projector. We recommend using this function in
combination of the Power management function.
• This function will not be available under the following conditions:
- when a component signal is applied to the ANALOG IN-1 connector
- when a Sync on Green RGB signal or composite sync signal is applied
- when [Power-saving] is selected for [Standby mode]
• To enable the Direct power on (Comp 1) after turning off the projector, wait 3 minutes and input an analog RGB signal.
If an analog RGB signal is still present when the projector is turned off, the Direct power on (Comp 1) will not work and the
projector remains in standby mode.
Enablng Power Management [Power management]
When this option is selected you can enable the projector to automatically turn off (at the selected time: 5 min., 10
min., 20 min., 30 min.) if there is no operation with no signal received by any input.
Selectng Default Source [Default source select]
You can set the projector to default to any one of its inputs each time the projector is turned on.
Last ....................... Sets the projector to default to the previous or last active input each time the projector is turned on.
Auto ....................... Searches for an active source in order of Computer 1
→ Computer 2 (Digital) → Computer 2 (Analog)
→ VIDEO → S-VIDEO → Computer 1 and displays the first found source.
Computer 1 ........... Displays the RGB source from the Computer 1 Input [ANALOG IN-1] connector every time the projector
is started up.
Computer 2 (Digital) ... Displays the DVI digital source from the Computer 2 Input [DIGITAL IN/ANALOG IN-2] (Digital) con-
nector every time the projector is started up.
Computer 2 (Analog) .. Displays the RGB analog source from the Computer 2 Input [DIGITAL IN/ANALOG IN-2] (Analog) con-
nector every time the projector is started up.
VIDEO .................... Displays the Video source from the VIDEO IN connector every time the projector is started up.
S-VIDEO ................ Displays the Video source from the S-VIDEO IN connector every time the projector is started up.