Cable Electronics e labs SW808HD - Manual (Page 24)

Page 20 Matrix Switching System—Instruction Manual
Disconnect all: Command Function Description
Use this command to close all the switching paths at one time. Press the Disconnect all key
to close connection to all input and output ports.
Memory Function Usage
Store and Retrieve Function Description
The Store Function saves all the present input/output switching relations to any
Locations from #1 to #8 desired. The Retrieve Function is used to retrieve these saved
input/output switching relations.
Store Function Example of the
Store all the present input/output switching relations to Location #1;
1. Select Location #1 ' as shown in the figure above,
2. Click the Save key to save all the present input/output switching relations to Location #1.
Retrieve Function Example
To retrieve the input/output corresponding relations saved in Location #1;
1. Select Location #1 as shown in the figure below
2. Click the Load key to retrieve all the input/output corresponding relations stored in
Location #1.
Scan Function Usage
Use the mouse to click the Scan key to refresh the AV Matrix operating interface.
Options Function Usage
This is an Activation Function for connecting a PC to a Matrix set.
1. In the main menu, select Options to
pop up the Options window.
2. In Port Number field, select either COM1
port or COM2 port.
3. In BAUD Rate select 9600 for signal
transmission
4. Select OK to finish.
9600
19600
COM1
COM2