FRIGIDAIRE FGGF3054MW - Manual (Page 31)

31
Step Press
1. The oven should be empty and all
oven racks removed. Remove
all items from the cooktop. Be sure
the oven door is completely closed.
2. Press delay start.
3. Enter 9 0 0.
4. Press start.
5. Press self clean once for a 3-hour
clean time, press self clean twice for
4-hour clean and press 3 times
for a 2-hour self-clean cycle time.
6. Press start to accept.
Example: To program a self-cleaning cycle with a
delay start time of 9:00 o’clock:
Setting a delay start self-clean cycle
1. Press keypad.
2. If the self-clean cycle has heated the oven to a high
temperature, the "Hot" (Fig. 1) message will show in
the display. Allow enough time for the oven to cool
and for the "door OPn" message to display (Fig. 2).
When this message turns off the oven door may be
opened.
If it becomes necessary to cancel self-clean:
Restarting a self-clean cycle after a power outage:
If a self-clean cycle was cancelled using the cancel
keypad before the oven was finished cleaning, you may
wish to set for another self-clean cycle.
If self-clean was cancelled shortly after being started, and
the oven interior did not reach high self-clean
temperatures, the next clean cycle may be set as soon as
the oven door unlocks from the cancelled clean cycle.
If the oven became hot enough from the cancelled self-
clean cycle, you may be required to wait up to 4 hours
before the control will allow another self-clean cycle to
start.
NOTES
• Check to be sure the oven is empty before setting a
self-clean cycle using a delay start setting.
Immediately after setting self-clean with delay start
the oven door will lock. The self-clean feature will not
start heating the oven for cleaning until reaching the
delay start time
• The maximum delay start setting is 11 hours & 59
minutes.
If a self-clean cycle was interrupted by a power failure,
your oven may not have thoroughly cleaned. If so, once
power is restored, the oven has cooled and the oven door
has unlocked, if needed, set again for self-clean.
Fig. 1 Fig. 2
Press cancel at any time to stop self-clean.
SELF-CLEANING
Starting another self-clean after cancellation:
NOTE
If attempting to set "back to back" self-clean cycles,
the control may display the messages "CLEAn" , then
"dELAy" followed by the length of time to wait before
the next self-clean may be set. For example, if the
message displayed shows "4:00", the control will not
allow for another self-clean cycle to start for the next 4
hours.