FRIGIDAIRE FPHS2399PF - Manual (Page 13)

13
CONTROLS
options
(∧ or ∨)
Used to enter and exit the
options menu and make
selections.
exit Toggles the options and run
modes.
control
locked
While in the locked state,
you will not be able to
change any settings on the
display nor dispense ice and
water. The “Control Locked”
indicator will flash and an
audible warning tone is
played.
light Toggles dispenser light On
and Off.
quick
freeze
on off
Activates a faster rate for
freezing food. Deactivates
after 12 hours.
quick ice
on off Increases the production
of ice. Deactivates after 12
hours.
display
on off
Toggles the temperature
displays On and Off.
refrigerator
temp
Allows the temperature set-
points to be adjusted. Control
temperatures range from
+33° F / +1° C to +47° F /
+8° C.
freezer
temp
Allows the temperature
set-points to be adjusted.
Control temperatures range
from -6° F / -21° C to +6° F
/ -15° C.
mode
° F ° C
Toggles display from Fahrenheit
to Celsius.
power off Press and hold for three
seconds to turn off the
cooling system. It also turns
off the ice maker and all
dispenser functions. The
display will read “power off”.
water filter Displays the current status of
the water filter (Good, Order,
or Replace). To reset the filter
status to “Good”, press and
hold the “set” key for three
seconds.
air filter Displays the current status of
the air filter (Good, Order, or
Replace). To reset the filter
status to “Good”, press and
hold the “set” key for three
seconds.
default
settings
While in the default option,
press and hold the set key
for three seconds to reset all
refrigerator settings to their
factory default settings.
set (+ or -) Selects the current menu
selection option.
water Press the “water” key
to select water. A green
indicator light will be
illuminated above the active
feature.
cube Press the “cube” key to
select cubed ice. A green
indicator light will be
illuminated above the active
feature.
crush Press the “crush” key
to select crushed ice. A
green indicator light will be
illuminated above the active
feature.
Setting cooling temperatures

NOTE
When you first power on the refrigerator,
the temperature displays 0° F and 37° F.
After a few seconds, both of the displays will
switch to “HI”. The displays will continue to
show “HI” for 20 minutes. After 20 minutes,
the High Temp alarm will sound and both
displays will show the actual temperature.
1 Plus (+) and Minus (-) indicators are
located on the right side of the control
panel.
2 Press the + or - indicator to adjust the
temperature to the desired setting.