FRIGIDAIRE FGIF3061NF - Manual (Page 12)

12
INDUCTION COOKING ZONES
Cooktop display windows
The range backguard provides a digital window for each of
the cooking zones located on the cooktop. Power levels and
messages are easily monitored and controlled using the
window displays in combination with the corresponding
control knobs.
Available power level settings
The cooktop control (Fig. 1) will display power levels
ranging from Pb (power boost, Fig. 2), Hi (Fig. 3) to Lo
(Fig. 4).
The settings between 9.5 (Fig. 5) and 1.5 (Fig. 7) decrease
and increase in 0.5 increments.
Use the “Suggested cooking zone power level settings
table” provided in Setting Surface Controls section to
determine the correct power level setting for the type of
food you are preparing.
The induction cooking zones will not operate when the
oven is set for Sabbath mode. For more details on the
Sabbath feature, see Setting Oven Controls section.
IMPORTANT
Pb (Power Boost) power level
When setting an induction cooking zone for Hi, the display
will initially show Pb (Power Boost) power level for up to 10
minutes (See Fig. 1). After 10 minutes the cooking zone will
automatically return to the Hi (Fig. 3) setting. The Pb
setting is only available immediately after activating a
cooking zone by turning the knob to Hi.
(HE) Hot surface window message
After using an induction cooking zone, the cooktop may
become very hot. After turning any cooking zone OFF, the
cooktop may remain HOT for some time. The
corresponding HE (hot element - Fig. 8) message will
remain ON until the cooktop has cooled.
ESEC Error Indicator Message (Er)
An error message will be displayed (flashing “Er”) (Fig. 6)
at power up (or after a power failure) if ANY of the surface
control knobs were left in the ON positions. If a power
failure should ocur, be sure to set all of the 4 surface
control knobs to the OFF position (See Fig. 1). This will
reset the surface controls.
Be sure to reset the clock (See page 19). Once the surface
controls have been set to the OFF positions and the clock
has been set with the correct time of day, the surface
controls should return to normal operation. If the surface
controls do not function and the “Er” message remains in
any display after following these procedures, contact an
authorized servicer for assistance.
(- -) Lockout window message
The (- -) message will appear whenever the Lockout, Self-
clean or Sabbath feature is active (See Fig. 9). Refer to the
Lockout instructions for more details.
Fig. 1
Fig. 3
Fig. 4
Fig. 6 Fig. 7
Fig. 8 Fig. 9
Fig. 5
Fig. 2