Acronis Backup for Linux Server - User Guide - Manual (Page 193)

193 Copyright © Acronis International GmbH, 2002-2014
Example
The diagram below shows what happens if you reassign a subscription to a different machine. Let's
assume Machine 1 has four backups in Subscription 1. Machine 2 has two backups in Subscription 2.
At that point, you reassign Subscription 1 to Machine 2. Machine 2 does its third backup to
Subscription 1.
Depending on your settings, this backup will be either full or incremental. But its size is not likely to
be less than a full backup size. Therefore, it is not practical to reassign a subscription to a machine
whose first backup was done as an initial seeding. You will need to either redo the initial seeding
(which requires a new license) or to transfer the sizeable backup over the Internet.
All earlier created backups remain intact. You can delete them manually if necessary. Keep in mind
though, backups can be deleted from a subscription only by the machine to which the subscription is
assigned. In our example, you have the following options.
Before reassigning
Delete backups from Subscription 1 using Machine 1 (if it is available and turned on). Delete backups
from Subscription 2 using Machine 2.
After reassigning
Delete backups from Subscription 1 using Machine 2. You cannot delete backups from Subscription 2,
unless you assign this subscription to any machine.
11.5 Configuring proxy settings
If the machine connects to the Internet through a proxy server, configure Acronis Backup to use the
proxy server.
1. Start Acronis Backup.