Acronis Backup for Linux Server - User Guide - Manual (Page 93)

93 Copyright © Acronis International GmbH, 2002-2014
The program will try to execute the failed task again if you select the Restart a failed task check box
and specify the number of attempts and the time interval between the attempts. The program stops
trying as soon as an attempt completes successfully OR the specified number of attempts is
performed, depending on which comes first.
If the task fails because of a mistake in the backup plan, you can edit the plan while the task is in the Idle state.
While the task is running, you have to stop it prior to editing the backup plan.
4.7.20 Task start conditions
This option is effective in Windows and Linux operating systems.
This option is not available when operating under bootable media.
This option determines the program behavior in case a backup task is about to start (the scheduled
time comes or the event specified in the schedule occurs), but the condition (or any of multiple
conditions) is not met. For more information on conditions please see Scheduling (p. 59) and
Conditions (p. 66).
The preset is: Wait until the conditions are met.
Wait until the conditions are met
With this setting, the scheduler starts monitoring the conditions and launches the task as soon as the
conditions are met. If the conditions are never met, the task will never start.
To handle the situation when the conditions are not met for too long and further delaying the backup
is becoming risky, you can set the time interval after which the task will run irrespective of the
condition. Select the Run the task anyway after check box and specify the time interval. The task will
start as soon as the conditions are met OR the maximum time delay lapses, depending on which
comes first.