FRIGIDAIRE FGHN2844LF - Manual (Page 12)

12
Door Handle Mounting Instructions for Frigidaire Professional ®
1 Remove handles from carton and any other protective packaging.
2 Position fresh food handle end over upper and lower pre-installed shoulder bolts (A)
that are fastened into door, ensuring the holes for the set screws are facing towards the
opposite door.
3 While holding handle firmly against door, fasten upper and lower Allen set screws (B) with
supplied Allen wrench.
4 Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing
towards the first door.
5 Position freezer handle end over left and right pre-installed handle mounts that are fastened
to the door, ensuring the holes for the set screws are facing down.
6 While holding handle firmly against door, loosely tighten far right Allen set screw (B) with supplied
Allen wrench until there is no gap between handle and door.
7 Still holding the handle firmly to the door, firmly tighten far left Allen set screw (B) with supplied Allen
wrench.
8 Return to the far right Allen set screw (B) and firmly tighten with supplied Allen wrench.
9 Firmly tighten the inside Allen set screws.
INSTALLING DOOR HANDLES

NOTE
All set screws should be
tightened so the screw is below
the surface of the handle. The
handles should be drawn tight
to freezer and refrigerator
doors with no gaps. Opening
the opposite door while
tightening the Allen screw makes
installation easier.
The door handle may loosen
over time or if it was installed
improperly. If this happens,
tighten the set screws on the
handles.
Mounting Refrigerator Handles
Mounting Freezer Handle
CAUTION
Wear gloves and safety goggles.
Use extreme CAUTION when
installing these handles.