FRIGIDAIRE FGHN2844LF - Manual (Page 6)

6
INSTALLATION
Toe Grille Must
Fit in Slot On
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
Leveling Freezer Drawer (if
necessary)
1 Check gasket seal around top, bottom,
and sides of freezer drawer.
2 If gasket is not sealed, open drawer and
slightly loosen four (4) drawer screws
(two (2) on each side) to allow drawer to
rotate.
3 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
To level the cabinet using the front
rollers (select models):
1 Slightly open freezer drawer. Lift the
toe grille and gently pull forward (see
illustration).
2 You can raise or lower each door. Use
a
3
/
8
inch socket wrench to turn the
adjustment screws (1 per side).
4 Tighten four (4) drawer screws.
5 Recheck gasket seal.
Raise
Lower
Anti-tip
Leg
Door Door
5 Install the toe grille by fitting into place.
Level Refrigerator & Adjust
Doors (if necessary)
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must rest
firmly on the floor.
• The sides should tilt 1 /
4
inch (6 mm) from
front to back (to ensure that doors close
and seal properly).
• Doors should align with each other and be
level.
Most of these conditions can be met by raising
or lowering the adjustable front rollers.
3 Ensure both doors are bind-free with their
seals touching the cabinet on all four sides
and that cabinet is stable.
4 After unit is leveled, lower anti-tip leg until
it contacts the floor.
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
Do Not Remove
Other Screws
Remove
hex
head
drawer
screw
Remove
Hex
Head
Drawer
Screw
Remove
hex
head
drawer
screw
Remove
Hex
Head
Drawer
Screw
Grab
Drawer
at
Center
from
Both
Sides
then
Pull
Drawer
Out
Push
Against
Freezer
Drawer
A
B