FRIGIDAIRE FPDF4085KF - Manual (Page 8)

8
40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
(Models with Electric Ovens and Gas Cooktop)
Range Installation
NOTE:
1. The back of the range may be installed directly
against the rear wall of the structure.
2. To reduce possible scorching of vertical walls and
to minimize potential fire hazards under abnormal
surface unit use conditions such as high heat or
no pans and to conform to C.S.A. requirements,
a minimum of 2½" (6.4 cm) spacing should be
provided on both sides of the cooktop.
3. If a wall is present on the left side of range, allow a
minimum of 2 3/4" (7 cm) to open the auxiliary door.
Preparation
1. Put on safety glasses and gloves. Remove oven racks
and parts package from inside the oven. Remove
shipping materials, tape and protective film from the
range.
2. Take 4 cardboard corners from the carton. Stack
one on top of another. Repeat with other 2 corners.
Place corners lengthwise on the floor in back of the
range to support range.
3. Firmly grasp the range and gently lay it on its back
on the cardboard corners.
4. Remove the 4 shipping bolts from the skid. Discard
skid.
5. Lay a large piece of cardboard in front of the range.
Carefully stand the range upright on cardboard.
6. Adjust the leveling legs to a point where the range
base does not touch the floor.
Leveling the Range
Level the range and set cooktop height before
installation in the cut-out opening (if applicable).
1. Install an oven rack in the center of the oven.
2. Place a level on the rack (see fig. 10). Take 2 readings
with the level placed diagonally in one direction
and then the other. Level the range, if necessary,
by adjusting the 4 leveling legs with a wrench (see
Figure 14).
3. Slide range into cut-out opening and double check
for levelness. If the range is not level, pull unit out
and readjust leveling legs, or make sure floor is level.
Figure 10
Figure 11
Gas
Opening
Burner Cap
Burner
Base
Electrode
Check Operation
Refer to the Use and Care Guide and the Electronic Oven
Control Guide packaged with the range for operating
instructions and for care and cleaning of your range.
Remove all packaging from the oven before testing.
1. Install Burner Bases and Burner Caps
This range is equipped with sealed burners as shown
(see Figure 11).
a. Unpack burner bases and burner caps.
b. Place burner bases over each gas opening.
c. Make sure the burner is properly aligned and
leveled. Place burner caps over appropriate
burner bases.
NOTE: There are no burner adjustments necessary on this
range.
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
Excessive Weight Hazard
• Use 2 or more people to move and install range.
• Failure to follow this instruction can result in
back or other injury.