Dell XPS M2010 (MXP061, Mid 2006) - Manual (Page 85)

Installing the CPU Fan
1. With the fan power cable oriented downward, align the rubber grommets in the fan with the holes in each corner of the processor airflow shroud, then
pull the grommets through until they snap into place.
2. Replace the processor airflow shroud (see Installing the Processor Airflow Shroud ).
3. Connect the fan cable to the FAN1_CPU connector on the system board (see System Board Components ).
4. Replace the computer cover (see Replacing the Computer Cover ).
5. Connect your computer and devices to electrical outlets, and then turn them on.
Removing the Optional Hard Drive Fan
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove all installed memory modules (see Removing Memory ).
4. Disconnect the fan cable from the FAN_HDD connector on the system board (see System Board Components ).
5. Press the release latch on the hard drive fan and slide it out from between the hard drive bays, then lift it from the computer.
NOTE: Airflow direction and orientation are shown on the side of the fan.
1 rubber grommet (4) 2 CPU fan 3 processor airflow shroud
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into your computer.