Dell PowerEdge 6850 User Manual
Page 18
Advertising
16
SAS Information Update
7 Remove the SAS backplane:
a
Press the spring-loaded blue retention tab at the back of the backplane, then slide the backplane
upward. See Figure 1-9.
b
When the backplane cannot slide upward any farther, pull the backplane toward the back
of the system to remove it from the retention hooks.
c
Lift the board out of the system, being careful to avoid damaging components on the face
of the board.
d
Place the SAS backplane face down on a work surface.
Figure 1-9.
Removing and Installing a 2.5-Inch SAS Backplane
1
2.5-inch backplane
2
retention tab
2
1
Advertising