See figure 1-11, D. see figure 1-11 – Dell PowerEdge 6850 User Manual
Page 21
Advertising
SAS Information Update
19
Figure 1-11.
Cabling the Peripheral Interposer Board
9 Remove the peripheral interposer board:
a
Press the spring-loaded blue retention tab at the back of the interposer board, then slide the board
upward. See Figure 1-12.
b
When the board cannot slide upward any farther, pull the board toward the back of the system
to remove it from the retention hooks.
c
Lift the board out of the system, being careful to avoid damaging components on the face
of the board.
d
Disconnect the backplane power cable from the front of the interposer board and place
the backplane power cable aside. See Figure 1-11.
e
Place the interposer board aside on a work surface.
1
control panel
2
power
3
data interface cable
4
backplane power
2
1
3
4
Advertising