Dell PowerEdge 6850 User Manual
Page 22
20
SAS Information Update
Figure 1-12.
Removing and Installing the Peripheral Interposer Board
Installing a Peripheral Interposer Board
1 Connect the backplane power cable to the front of the interposer board. See Figure 1-11.
2 Install the peripheral interposer board:
a
Carefully lower the interposer board into the system, being careful to avoid damaging components
on the face of the board. See Figure 1-12.
b
Align the installation alignment slot on the bottom of the interposer board with the alignment pin
on the bottom of the chassis.
c
Slide the retention slots on the interposer board over the retention hooks on the chassis.
d
Slide the board downward until the blue retention tab snaps into place.
1
retention tab
2
installation alignment slot
3
peripheral interposer board
3
1
2