Quality troubleshooting – Cissell CAB438C User Manual
Page 22
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
AJ0975
20
Quality Troubleshooting
Figure 20
CAB263N
CAB263N
SHIRT QUALITY
1
1
4
3
2
3
7
5
5
7
6
4
Trouble
Probable Cause
Solution
Damp patches
on sleeve
(item 1)
1. Cycle time too short.
Increase Timer.
2. Boiler pressure too low.
Adjust pressure.
3. Faulty trap or check valve in steam return
line from condensate tank.
Clean, repair or replace faulty trap or check valve.
4. Steam supply coming from bottom of
header, no riser.
Correct inlet piping. Refer to Installation Manual.
Placket bowing
at the button
strips (item 2)
1. Operator pulling shirt too tightly on buck.
Dress shirt so it hangs in natural “A.” Refer to Buck
Dressing Instructions.
2. Shirt not held in place by vacuum.
Fan or draft in plant blows shirt during transfer.
Redirect fan. Close window or door which causes draft.
Check for hole or collapsed hoses. Flannel padding is
too thick. Install thirty ounce (30 oz.) flannel padding.
3. Air remains in side air bags at end of
pressing cycle and distorts shirts.
Damper to heat exchanger is not closing off or is not
closing off soon enough. Adjust as necessary.
4. Air to side air bags distorts shirt before
heads begin to press.
Adjust high pressure air to buck air bags.
Table 2 (Continued)