Compaq MP1400 - Manual (Page 14)

MP1400 Microportable Projector 1-7
Part Number: part number 177284-001 - Writer: Marianne Silvetti - Saved by: Marianne Silvetti
Pages: 18 Words: 2366 Saved date: 05/12/004:32 PM File Name: Chap1.doc
Connecting the Projector to a Desktop Computer
1. Rotate the elevator foot to balance the projector.
2. Connect one end of the projector signal cable
1B to
the projector and the other end to the VGA connector
on the desktop computer and tighten the screws.
✎
If your computer has a digital connector, connect one end of
the digital flat panel (DFP) signal cable
1A to the digital
connector on the projector and the other end to the digital
connector on the computer. Connect either the VGA cable
OR the DFP cable; do not connect both cables.
✎ Be sure the signal cable aligns with the connector. Do not
force the cable onto the connector or you may damage the
signal cable or the projector.
3. Connect one end of the power cord
2 into the back
of the projector, and the other end to an electrical
outlet that is easily accessible and close to the
projector.
4. Turn on the projector first, then turn on the computer.