How to create the program, Configuration manager – Crestron electronic 3200 User Manual
Page 20
CRESTRON
containing a CNMSX-PRO which has a CNXRY-16 occupying slot 1. Assume that
the CT-3200 is used to control a lighting system via relays in two rooms. Each room
can have up to eight scenes of lighting. A scene is engaged by latching a relay. Only
one scene can be activated in a room at a time.
Block Diagram of System Incorporating a CT-3200
Room 1 uses relays A1 through A8; room 2 uses relays B1 through B8. When the
user presses any of the buttons on the CT-3200 for room 1 (join numbers 1 through
8), the corresponding signal goes high on the input of the Interlock symbol for room
1. The corresponding output of the Interlock latches high. Since the Interlock is
mutually exclusive, only that output is high. The corresponding relay then latches
high on the CNXRY-16 card.
How to Create the Program
Configuration Manager
Use the Configuration Manager workspace (Project | Configure System) in SIMPL
Windows to select and configure all the devices that need to be included into the
system. For this example, add a CNXRY-16 to slot #1 of the CNMSX-PRO. Also
add a CT-3200 to the system; its NET ID must be set to 03, shown on the next page.
NOTE: SIMPL Windows v1.21.04 or later is required to program the control
system containing a CT-3200 touchpanel. If using an earlier version of SIMPL
Windows, Crestron recommends a SIMPL Windows and operating system upgrade.
The latest version can be obtained from the Software Downloads page of Crestron’s
webs
. New users are required to register in order to obtain
access to the FTP site.
16
• Series 3200 Touchpanels
Operations Guide - DOC. 5725