Clarion ADZ625 - Manual (Page 8)

12
ADZ625
7. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
CAUTION
Be sure to lower the volume before switch-
ing off the unit power or the ignition key. The
unit remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.
The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (igni-
tion-on) position even when the unit power is
off. In some cars, the clock may momentarily
disappear when the ignition key is turned to
the START position. The clock will reappear
after the engine has started and the ignition
key is released to the IGN (ignition-on) posi-
tion.
Turning on/off the power
Notes:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
• System check
This unit checks what external equipment is con-
nected to the CeNET. The first time the ACC/Igni-
tion is turned on (initialization), “SYSTEM” and
“Push PWR” alternately blink in the display. Press
the [FNC] button to start the system check. When
complete, press the [FNC] button again to activate
the unit then the unit appears CHECKING COM-
PLETE.
1. Press the [FNC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [FNC] button for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press the [FNC] button to change the mode
of operation.
2. Each time you press the [FNC] button, the
mode of operation changes in the following
order:
Radio mode
➜ CD mode ➜ Tape mode ➜
CD changer mode
➜ MD changer mode ➜
TV mode
➜ AUX mode ➜ Radio mode...
∗ External equipment not connected with CeNET
is not displayed.
Adjusting the volume
Turn the [VOLUME] knob clockwise to increase
the volume, or turn the [VOLUME] knob coun-
terclockwise to decrease the volume.
∗ The volume level is from 0 (minimum) to 33 (maxi-
mum).
Switching the display
Press the [DISP] button to select the desired dis-
play.
Each time you press the [DISP] button, the dis-
play switches in the following order:
Main display
Clock(CT) display
Main display
Sub (title) display
∗ Once selected, the preferred display becomes
the display default. When a function adjustment
such as volume is made, the screen will mo-
mentarily switch to that function’s display, then
revert back to the preferred display several
seconds after the adjustment.
∗ When you have entered a title in a CD, it ap-
pears in the sub display. If you have not en-
tered a title, “NO-TTL” appears in the title dis-
play instead. For information on how to enter a
title, refer to the subsection “Entering titles”
in the “Operations Common to Each Mode”.
∗ You can adjust the way of scrolling a title. For
the details on it, refer to the subsection “Ad-
justing the way of scrolling” in the
“Operations Common to Each Mode”.