Dell UPS 1000T - Manual (Page 19)

Installation 19
Configuration
When started, the application automatically performs a discovery using the “Quick Scan” option for the
following UPSs:
• Serial line connected UPSs (RS-232 or USB)
The discovered UPS connected through an RS-232 or USB connection is automatically assigned as
the Power Source. The Status icon is automatically green in the Node List page (see Figure 4).
• Networked UPSs through broadcast within a few seconds. “Quick Scan” is compatible with
Web/SNMP Cards such as the Dell Network Management Card (H910P).
The discovered Networked UPSs are not automatically assigned as the Power Source. You must
select the node and click Set as Power Source. The Status icon becomes green in the Node
List page (see Figure 4).
The Edit Shutdown Configuration dialog box displays (see Figure 5). You can configure your
power source now or by using the “Edit shutdown configuration” setting, which will show the
same configuration dialog box.
• The discovered nodes are displayed using Settings > Auto Discovery (see Figure 4).
For the other nodes, perform the discovery based on IP address ranges using the “Range Scan” option.
Using “Range Scan” discovers the nodes that are outside of the network segment (subnet).
(Optional) Use Settings > Shutdown to display the Edit Power Source dialog box and assign the
following:
• IP address of the UPS that powers the local Computer (if not already set by the previous step).
• Use Settings > User List to assign access rights for users through the login and password entries.
Figure 4. Quick Start - Auto Discovery Page
0120_3-Dell ULNM UG.book Page 19 Saturday, November 2, 2013 5:34 PM