Clarion CX501 - Manual (Page 13)

English
13
CX501
SIRIUS Satellite Radio Operations
This function is available when this unit is
connected to the SCC1, SiriusConnect Vehicle
Tuner, (sold separately) with the SIRIUS SSP
cable.
Selecting a Satellite Radio mode
1. Press the [SOURCE] button.
The system changes to the specified
Satellite Radio mode.
Selecting a band
1. Press the [BAND] button to select a band.
This changes the reception band as follows:
SR1 ➜ SR2 ➜ SR3...
● Information displayed during reception
The following information is displayed when the
satellite radio cannot be received normally.
• When the tuner is not being connected: “NO
TUNER”.
∗ In this time, please turn off the power and
connect the tuner to this unit.
• When the antenna is not being received:
“
ANTENNA ERROR”.
• When no signal is received: “NO SIG”.
• When the contract of the channel is being
updated: “SUB UPDT”.
• When the channel map is being updated:
“UPDATING”.
• A channel without a broadcast has been
selected: “INVALID CH”.
• A channel not covered by your contract:
“UNSUB CH” (alternated)
• When simulate firmware update: “F/W
UPDATE”.
Confirming your SIRIUS ID
1. Switch to channel 0.
∗ For details, see the following operation
descriptions.
2. The SIRIUS ID appears in the display.
Displaying channel labels
1. Press the [DISP] button to select the desired
channel label.
Channel
➜ Category ➜ Title (Artist) ➜
Composer
➜ Channel...
Channel input directly
This function allows you to input the channel No.
directly.
1. Press and hold the [DISP] button.
2. Press the [
x] or [v] button to select
“DIRECT”.
3. Press the [ROTARY] knob.
4. Press the [
x] or [v] button to move the
cursor.
5. Turn the [ROTARY] knob to select a number.
6. Press and hold the [ROTARY] knob.
Notes:
• If no operation is performed within 10 seconds, it
will return to the previous mode.
• If you select the Parental Locked channel, the
“CH LCKED” will appear in the display for 2 sec.
Then it will remind you to enter the password (For
details, see the chapter “Parental Lock
function” (page 14)).
Channel selection
1. Channels are selected with the [
x] or
[
v] button.
∗ For details, see the following operation
descriptions.
Notes:
• The audio output is muted and other button
operations are not accepted during channel
selection.
• The Parental Locked, unsubscribed and invalid
channels will be skipped and can not be tuned.
Recalling a preset station
A total of 18 satellite radio stations can be
stored.
6-SR1, 6-SR2 and 6-SR3
This allows you to store your favorite satellite
radio stations in memory for later recall.
1. Press the [BAND] button to select the
desired band.
2. Turn the [ROTARY] knob to select the
desired preset station.
Preset memory
1. Press the [BAND] button to select the
desired band.
2. Select the desired channel.
3. Press and hold the [DIRECT] button (2 sec.)
to store the current channel into preset
memory.
CX501_ENG.book Page 13 Thursday, November 4, 2010 3:55 PM