Clarion CX501 - Manual (Page 9)

English
9
CX501
5. OPERATIONS
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 6.
Basic Operations
CAUTION
Be sure to lower the volume before
switching off the unit power or the ignition
key. The unit remembers its last volume
setting.
Turning on/off the power
1. Press the [SOURCE] button to turn on the
power.
2. Press and hold the [SOURCE] button
(1 sec.) to turn off the power for the unit.
Selecting a mode
1. Press the [SOURCE] button to change the
operation mode.
2. Each time you press the [SOURCE] button,
the operation mode changes in the following
order:
Tuner (HD Radio)
➜ (SIRIUS Satellite radio)
➜ CD/MP3 ➜ USB/iPod ➜ BLUETOOTH ➜
AUX
➜ Tuner (HD Radio)...
∗ iPod can connect to this unit via USB cable.
∗ iPhone can also be connected to this system
and “iPod” appearing in this manual should be
referred to as “iPod/iPhone”.
Adjusting the volume
1. Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
Press the [DISP] button to select the desired
display.
Sound Adjustment
You can adjust a sound effect or tone quality to
your preference.
● Setting the BEAT EQ
This unit is provided with 4 types of sound tone
effects stored in memory.
Select the one you prefer.
∗ The factory default setting is “OFF”.
2-1. Select “BEAT EQ” .
To change sound setting
1. Press the [SOUND] button to switch to the
sound adjustment selection display.
∗ The factory default sound setting is
“BEAT EQ”.
2. Then press the [
x] or [v] button to
select the sound adjustment mode.
Each time you press the [
x] or [v]
button, the sound adjustment mode
changes as following order:
“BEAT EQ”
↔ “M-B EX” ↔ “BALANCE” ↔
“FADER”
↔ “LPF” ↔ “S-W VOL” ↔
“PHASE”
↔ “HPF”
∗ In the case of display blinking
“ENT” , you
can press the [ROTARY] knob to adjust the
setting value.
3. Turn the [ROTARY] knob to adjust the
selected sound mode.
4. After completing settings, press the
[SOUND] button to return to the previous
mode.
CX501_ENG.book Page 9 Thursday, November 4, 2010 3:55 PM