CyberData VoIP Loudspeaker Amplifier Part #010859 - Manual (Page 17)

Installing the VoIP Loudspeaker Amplifier
Loudspeaker Amplifier Setup
VoIP Loudspeaker Amplifier Operations Guide 930111F CyberData Corporation
9
See Table 2-5 for details about connecting the loudspeaker amplifier.
2.2.3.1 Using the Line Out Output
Figure 2-6. Using the Line Out Output
2.2.3.2 Loudspeaker Type
The CyberData VoIP Loudspeaker Amplifier supports an 8 Ohm Bogen or equivalent unamplified
loudspeaker. See
Figure 2-7 .
Table 2-5. Loudspeaker Amplifier Connections
Connection Connection Details Location
Loudspeaker ● Use two binding posts for up to 0.083 inch
diameter loudspeaker wire. VoIP paging amplifier
Ethernet ● Use a RJ 45 cable. VoIP paging amplifier
AC
a
a.Prior to installation, consult local building/electrical code requirements.
● For a phase connection, use a press-down
connector for 14 AWG solid copper wire.
● For a neutral connection, use a press-down
connector for 14 AWG solid copper wire.
● For an earth/ground connection, use a screw-
down connector for 14 AWG solid copper wire.
AC panel