CyberData VoIP Loudspeaker Amplifier Part #010859 - Manual (Page 35)

Installing the VoIP Loudspeaker Amplifier
Upgrade the Firmware and Reboot the Loudspeaker Amplifier
VoIP Loudspeaker Amplifier Operations Guide 930111F CyberData Corporation
27
2.5.1 Reboot the Loudspeaker Amplifier
To reboot a loudspeaker amplifier, log in to the web page as instructed in Section 2.3.1, "Log in to the
Configuration Home Page" .
1. Click Upgrade Firmware to open the Firmware Upgrade page ( Figure 2-18 ). Use the Reboot
System section on the right side of the page.
Application Shows the current application filename for partition 1
and 2.
Load new firmware to Partition 1 Enter the TFTP Server IP address.
New Filename Enter the new file name for the kernel or application
firmware file that you are uploading.
Click on this button to automatically upload the selected
firmware and reboot the system.
Link to the Speaker Setup page.
Link to the Network Setup page.
Link to go to the SIP Setup page.
Link to the MGROUPS Setup page.
Link to the Home page.
Click on this button to reboot the system.
Table 2-13. Firmware Upgrade Parameters (continued)
Web Page Item Description