Dell Alienware M18x R2 (Early 2012) - Manual (Page 27)

Replacing the Center Control Cover | 29
Replacing the Center Control
Cover
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Slide the central control cover cable into the connector on the system board and
press down on the connector latch to secure the cable.
2 Align the tabs on the center control cover with the slots on the palm-rest assembly
and snap the center control cover into place.
3 Close the display and turn the computer over.
4 Replace the screws that secure the center control cover to the computer base.
Postrequisites
1 Replace the base cover. See "Replacing the Base Cover" on page 15.
2 Replace the battery pack. See "Replacing the Battery Pack" on page 13.
3 Follow the instructions in "After Working Inside Your Computer" on page 11.
14
Book.book Page 29 Thursday, June 7, 2012 3:01 PM