Chaparral VFS113 User Manual

Page 3

Advertising
background image

i

Copyright

© 2000, 2001 Chaparral Network Storage, Inc.
Document Number: 07-0015-006-B
This document covers the VFS113.
All rights reserved. No part of this publication may be reproduced without the prior written consent of:

Chaparral Network Storage, Inc.
7420 E. Dry Creek Parkway
Longmont, Colorado 80503

http://www.chaparralnet.com

Trademarks

Chaparral Network Storage, Inc. and the Chaparral logo are trademarks of Chaparral Network Storage, Inc.

AHA and AIC are trademarks of Adaptec, Inc.

Windows is a registered trademark and Windows NT is a trademark of Microsoft Corporation in the U.S. and
other countries, used under license.

All other trademarks are owned by their respective owners.

Changes

The material in this document is subject to change without notice. While reasonable efforts have been made to
ensure the accuracy of this document, Chaparral Network Storage, Inc. assumes no liability resulting from
errors or omissions in this publication, or from the use of the information contained herein.

If you would like to provide comments or suggestions on the quality and/or accuracy of this manual, please
contact Chaparral at

http://www.chaparralnet.com/manuals

.

Chaparral reserves the right to make changes in the product design without reservation and without
notification to its users. Comments and suggestions can be sent to the address listed above.

Technical Support

If after reviewing this user’s guide, you still have questions about installing or using your Chaparral product,
please contact us at (303) 845-3200 or by e-mail at

[email protected]

Federal Communications Commission Radio Frequency Interference Statement

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. However, if this equipment does cause interference to radio or television equipment
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Use a shielded and properly grounded I/O cable and power cable to ensure compliance of this unit to the
specified limits of the rules.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Advertising