Chaparral VFS113 - Manual (Page 4)

ii
Canadian Compliance Statement
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matérial brouilleur du
Canada
EMC
Documents:
89/336/EEC—European Council Directive on the Approximation of the Laws of the Member states Relating
to Electromagnetic Compatibility (EMC Directive).
Testing:
Emissions: EN 55022
Immunity: EN 50082-1
Emissions
Documents:
1 CISPR Publication 22/EN 55024—Limits and Methods of Measurement of Radio Interference
Characteristics of Information Technology Equipment (ITE).
2 Federal Communications Commission (FCC)
a) 47 Code of CFR, chapter I
i) Part 2—Frequency Alloc. And radio Treaty Matters; Gen. Rules and Reg.
(1) Subpart J - Eq. Auth. Procedures
ii) part 15—Radio Frequency Devices
(1) Subpart B - Unintentional Radiators
3 ANSI C63.4—Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and
Electronic Eq in the Range of 9 kHz to 40 GHz
4 ICES-003—Interference - Causing Eq Standard - Digital Apparatus
5 AS/NZS 3548—Limits and Methods of Measurement of Radio Disturbance Charac. of Info. Tech. Eq.
6 VCCI—Volunt. Control council for Interference by Info. Tech. Eq.
Test setup shall conform to ANSI C63.4
Testing to be performed to CISPR 22/EN55022 Class-A and FCC Class-A limits
The quasi-peak detection mode is to be used for measurements from 30 MHz to 1 GHz and the antenna should
be placed at a distance of 10 meters from the Equipment Under Test (EUT). To comply with the FCC Rules
and Regulations, testing must be performed to 5.3125 GHz (the 5th harmonic of the 1.0625 GHz clock) at a
test distance of 3 meters using the average detection mode.
Immunity
1 EN 50082-1: 1998—Electromagnetic Compatibility - Generic Immunity Standard - Part 1: Residential,
Commercial and Light Industry
2 EN 61000-4-2—Electromagnetic Compatibility (EMC) - Part 4: Testing and Measurement Techniques -
Section 2; Electrostatic Discharge Immunity Test
3 EN 61000-4-3—Electromagnetic Compatibility (EMC) - Part 4: Testing and Measurement Techniques -
Section 3: Radiated, Radio Frequency, Electromagnetic field Immunity Test
4 EN 61000-4-4—Electromagnetic Compatibility (EMC) - Part 4: Testing and Measurement Techniques -
Section 4: Electrical Fast Transient/Burst Immunity Test
5 EN 6100-4-5—Electromagnetic Compatibility (EMC) - Part 4: Testing and Measurement Techniques -
Section 5: surge Immunity Test