Raid battery (optional), Removing the raid battery – Dell PowerEdge T310 User Manual

Page 132

Advertising
background image

132

Installing System Components

13 Close the system. See "Closing the System" on page 86.
14 Place the system upright on a flat surface.
15 Reattach any peripherals and connect the system to an electrical outlet.
16 Turn on the system and attached peripherals.
17 Enter the System Setup program to confirm that the battery is operating

properly. See "Entering the System Setup Program" on page 58.

18 Enter the correct time and date in the System Setup program's Time and

Date fields.

19 Exit the System Setup program.

RAID Battery (Optional)

Removing the RAID Battery

The information in this section applies only to systems with the optional
PERC controller card.

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

2 Open the system. See "Opening the System" on page 85.
3 Remove the expansion card stabilizer. See "Removing the Expansion Card

Stabilizer" on page 87.

4 Remove the storage controller card. See "Removing an Expansion Card" on

page 118.

5 To disconnect the RAID battery cable from the connector on the storage

card, press the tab on the RAID battery cable connector, and gently pull
the cable connector out of the connector on the storage card.
See Figure 3-25.

6 Pull the battery carrier release tab, and lift the battery carrier out of the

battery carrier slots on the chassis. See Figure 3-25.

7 Pull back gently on the two tabs holding the RAID battery and lift the

RAID battery from the battery carrier. See Figure 3-25.

book.book Page 132 Wednesday, August 19, 2009 4:40 PM

Advertising