Dell PowerEdge T310 - Manual (Page 25)

About Your System
25
LCD Status Messages
The LCD messages consist of brief text messages that refer to events recorded
in the System Event Log (SEL). For information on the SEL and configuring
system management settings, see the systems management software
documentation.
NOTE:
If your system fails to boot, press the System ID button for at least five
seconds until an error code appears on the LCD. Record the code, then see "Getting
Help" on page 177.
No memory modules
detected. See "Troubleshooting System
Memory" on page 155.
System board failure. See "Getting Help" on page 177.
Memory configuration
error. See "Troubleshooting System
Memory" on page 155.
Possible system board
resource and/or system
board hardware failure. See "Getting Help" on page 177.
Possible system resource
configuration error. See "Getting Help" on page 177.
Other failure. Ensure that the diskette drive,
optical drive, and hard drives are
properly connected. See
"Troubleshooting Your System" on
page 147 for the appropriate drive
installed in your system. If the
problem persists, see "Getting
Help" on page 177.
Table 1-1. Diagnostic Indicator Codes (continued)
Code Causes Corrective Action
book.book Page 25 Wednesday, August 19, 2009 4:40 PM