Dell PRECISION 530 - Manual (Page 66)

66
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
From inside the cover, press the ends of the insert outward with your
finger until the insert snaps free of the front panel.
NOTE: If you are installing a hard drive, do not remove the drive bay
insert.
13 Close the computer cover .
14 Stand the computer upright.
15 Reconnect the computer and devices to their electrical outlets, and
turn them on.
NOTE: If enabled, the Chassis Intrusion option will cause the following
message to be displayed at the next computer start-up:
ALERT! Cover was previously removed.
16 Enter system setup and update your drive configuration information:
• Reset the Chassis Intrusion option, as described in your User’s
Guide.
• If you installed a diskette drive, update the Diskette Drive A
option to enable your new diskette drive.
• If you installed an EIDE CD, zip, or tape drive, set the appropriate
Drive option (0 or 1) under Secondary Drives to Auto.
• If you installed a hard drive, update the drive settings under
Primary Drives.
After you update the system settings, exit system setup and reboot the
computer.
17 If you installed a hard drive, partition and logically format the drive
before proceeding to the next step.
See the operating system’s documentation for instructions.
18 Test the drive to verify that it is operating properly.
• If the drive you installed is a hard drive, run the Dell Diagnostics
to test the drive.
• For other types of drives, see the drive’s documentation for
information on testing the drive.
NOTE: Tape drives sold by Dell come with their own operating software
and documentation. After you install a tape drive, refer to the
documentation that came with the drive for instructions on installing and
using the tape drive software.