Dell PRECISION 530 User Manual
Page 86
86
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
7
Lower the expansion card retention arm and press it into place,
securing the expansion card(s) in the chassis.
8
Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's
cable connections.
NOTICE:
Do not route expansion card cables over or behind the expansion
cards. Cables routed over the expansion cards can prevent the computer cover
from closing properly or cause damage to the equipment. Cables routed toward
the rear of the expansion cards can prevent proper airflow from the expansion-
card cooling fan.
9
10
Stand the computer upright.
11
Reconnect the computer and devices to their electrical outlets, and
turn them on.
NOTE:
If enabled, the Chassis Intrusion option will cause the following
message to be displayed at the next computer start-up:
ALERT! Cover was previously removed.
Enter system setup and reset the Chassis Intrusion option as
described in your User’s Guide.
12
If you installed a sound card, perform the following steps:
a
Enter system setup, clear the security field, select Integrated
Devices and change the setting for Sound to Off.
b
Connect external audio devices to the sound card’s connectors.
Do not connect external audio devices to the microphone,
speaker/headphone, or line-in connectors on the computer back
panel (see "Back-Panel Features").
13
If you installed an add-in network adapter, perform the following steps:
a
Enter system setup, select Integrated Devices and change the
setting for Network Interface Card to Off.
b
Connect the network cable to the add-in network adapter’s
connectors. Do not connect the network cable to the integrated
connector on the computer back panel (see "Back-Panel
Features").