CyberPower Systems Network Management Card - Manual (Page 12)

Cyber Power Network Management System
10
[UPS Reboot] allows advanced remote control of the UPS. Select one function by clicking its
button. Click [Apply] to begin the operation. Select [Cancel] to refresh the selection.
Note: The commands in [UPS Reboot] menu may change by the settings in the [UPS Schedule]
menu.
Commands Definition
Reboot UPS Immediately To turn the UPS off and then on again.
Delay 03 min(s) to Reboot
UPS
3 minutes is a default value. The user may select any
number between 1-99. The UPS will shut off and wait
the set amount of time before turning back on.
Cancel Reboot UPS
To stop the previous command “Delay 03 min(s) to
Reboot UPS.
Turn Off UPS Immediately To turn the UPS off immediately.
Delay 03 min(s) to Turn Off
UPS
3 minutes is a default value. The user may select any
number between 1-99. The UPS will wait the set
amount of time before turning OFF.
Cancel Turn Off UPS
To stop the previous command “Delay 03 min(s) to
Turn Off UPS
Turn On UPS Immediately To turn on UPS when it is turned off.