CyberPower Systems Network Management Card - Manual (Page 7)

Cyber Power Network Management System
5
Figure 2. The SNMP card setting window.
6. First, choose either IP or MAC address from the device address option.
7. Then click on each checkbox to modify the IP, subnet mask or gateway address. Enter the
new addresses into the corresponding fields.
8. You will need to input password for the SNMP card (Figure 3) in the authentication window,
as shown in figure 3. *Default User name: cyber; Default Password: cyber
Figure 3. Authentication window.
9. If you set IP address successfully, you will receive the IP set up OK message, as shown in
figure 4.