Dell 5310n Mono Laser Printer - Manual (Page 56)

Custom Types
This menu selection is used to define a name for each custom paper type. You can assign names from the operator panel.
Universal Setup
This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal Paper Size, the
printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up.
Bin Setup
This menu selection is used to specify the output bin where you want your printed material to go to.
single-sided job. Off*
Vinyl Labels
Loading
Bond Loading
Letterhead
Loading
Preprinted
Loading
Colored Loading
Card Stock
Loading Properly handles preprinted card stock whether the job is a duplexed or
single-sided job. Duplex
Off* Shown if Card Stock is supported in the specified
input source.
Custom <x>
Loading Properly handles preprinted custom paper whether the job is a duplexed
or single-sided job. Duplex
Off* Shown if the custom type is supported in the
specified input source.
Menu
selection: Purpose: Values:
Custom
Type N Specifies the type of paper associated with each Custom
Type available in the Paper Type menu. Paper*
Card Stock
Transparency
Labels
Vinyl Labels
Envelope The custom type media must be supported in the input source you
designate in order to assign a user-defined name.
Once the name is assigned, the name (truncated to 16 characters)
will be displayed instead of Custom Type x.
Menu
selection: Purpose: Values:
Units of
Measure Determines the unit of measure used to enter the
Universal Height and Width. Inches
Millimeters Inches is US default; Millimeters is international default.
Portrait
Width Sets the portrait width of the universal media.
NOTE: If the value set exceeds the maximum width,
the printer will use the maximum value allowed in
inches or millimeters.
3 inches to 14.17 inches
in 0.01 inch increments
(76 mm to 360 mm in 1
mm increments)
Shows either inches or millimeters from Units of Measure
setting; 8.5 inches is the US default, and 216 mm is the
international default.
Portrait
Height Sets the portrait height of the universal media.
NOTE: If the value set exceeds the maximum height,
the printer will use the maximum value allowed in
inches or millimeters.
3 inches to 14.17 inches
in 0.01 inch increments
(76 mm to 360 mm in 1
mm increments)
Shows either inches or millimeters from Units of Measure
setting; 14 inches is the US default, 356 mm is the
international default.
Feed
Direction Specifies the feed direction of the Universal Paper
Size. Short Edge*
Long Edge Long Edge is only shown if the longest edge is shorter
than the Maximum Physical Width of the printer.
NOTE: Bin Setup is only displayed when at least one optional output bin is installed.
Menu
selection: Purpose: Values:
Output Bin Specifies the default bin for printed material. Standard Bin*
Bin <x> l If a user-defined name is available, it appears
instead of Bin <x>.
l The name is truncated to 14 characters.
l If two or more bins share the same name, the
name only appears once in the Output Bin value
list.
Configure
Bins Determines which output bin(s) the printer uses for a particular
job. Mailbox Sends print jobs to the output bin designated for that
user.
Link* Links two or more bins together as though they were
one large bin. When one linked bin is full, the printer
starts filling the next linked bin, and continues with each
additional linked bin.
Mail Overflow Sends print jobs to the output bin designated for that