Dell POWEREDGE M1000E - Manual (Page 247)

Web Tools Administrator’s Guide 219
53-1001772-01
Authentication policy configuration
17
DRAFT: BROCADE CONFIDENTIAL
3. Under Security Policies, click FWCP.
4. Select one of the following consistency behavior for the required policy type (SCC, DCC, FCS).
• Absent
• Tolerant
• Strict
NOTE
You can change the consistency behaviors of SCC, DCC, or FCS policy only for a primary switch.
5. Click Apply.
6. Click Yes to accept the changes.
NOTE
If the switch is not a primary switch, an error message dialog box displays.
7. Click No to discard the changes and click Refresh in the FWCP Configuration window to
manually refresh the window.
8. Click Close.
Authentication policy configuration
You can configure an authentication protocol policy for E_Port and F_Port authentication, and then
distribute the authentication policy to other switches in the fabric. You can also set shared secret
keys.
Configuring authentication policies for E_Ports
Use the following procedure to configure authentication policies for E_Ports.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Select the Security Policies tab.
3. Select Authentication on the Security Policies menu.
4. In the Authentication Type field, select FCAP or DHCHAP.
5. Select the switch authentication policy mode:
:
On Strict authentication is enforced on all E_Ports.
Active The switches can be connected to a switch with any
type of policy.