Dell PowerEdge 7250 - Manual (Page 21)

SR870BN4 Error Reference Guide BIOS POST Error Codes and Messages
Revision 1.0 15
Error Code Error Message Pause on Boot Recommended User Action
8151 Processor 02: failed initialization
on last boot Yes; user input required Retest processor. If error
persists, hardware failure. User
should replace processor.
8152 Processor 03: failed initialization
on last boot Yes; user input required Retest processor. If error
persists, hardware failure. User
should replace processor.
8153 Processor 04: failed initialization
on last boot Yes; user input required Retest processor. If error
persists, hardware failure. User
should replace processor.
8180 BIOS does not support current
stepping for Processor 01 Yes User should replace processor
with a supported stepping.
8181 BIOS does not support current
stepping for Processor 02 Yes User should replace processor
with a supported stepping.
8182 BIOS does not support current
stepping for Processor 03 Yes User should replace processor
with a supported stepping.
8183 BIOS does not support current
stepping for Processor 04 Yes User should replace processor
with a supported stepping.
8193 CPUID, Processor Steppings are
different Yes Use processors with the same
stepping (e.g. C0, C1). User
information, typically n and n -1
stepping mixes allowed.
8194 CPUID, Processor Families are
different Yes; user input required Use processors that are the
same speed. CPUID has 3
fields=>stepping, family and
model. If any of the fields
mismatch, then user would get
this message. User has to
replace processor with the same
kind.
8196 Processor Models are Different Yes; user input required Use processors that are the
same speed and stepping.
8197 Processor Speed mismatch Yes Use processors that are the
same speed and stepping.
8300 Baseboard Management
Controller failed to function
Yes Try to reflash the BMC with the
most current version that is
compatible with your system
configuration. If problem
persists, may require board
replacement.
84F3 Baseboard Management
Controller in Update Mode
Yes; user input required The BMC recovery jumper is in
the active position and the BMC
can be reflashed. After
reflashing, move the jumper to
the inactive position.
84FF System Event Log Full Yes Clear the SEL in BIOS setup.
8500 Multi-bit Error Detected Row1.
Row 1 mapped out Yes Verify the affected memory and
replace with correct memory.
8501 Multi-bit Error Detected Row2.
Row 2 mapped out Yes Verify the affected memory and
replace with correct memory.
8502 Multi-bit Error Detected Row3.
Row 3 mapped out Yes Verify the affected memory and
replace with correct memory.
8503 Multi-bit Error Detected Row4.
Row 4 mapped out Yes Verify the affected memory and
replace with correct memory.