Removing an idrac6 express card (optional), Down until it is fully seated. see figure 3-14 – Dell PowerVault NX300 User Manual
Page 104
104
Installing System Components
Figure 3-14.
Installing or Removing an iDRAC6 Express Card (Optional)
5 Close the system. See "Closing the System" on page 83.
6 Reconnect the system and peripherals to their power sources, and turn
them on.
Removing an iDRAC6 Express Card (Optional)
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
1
iDRAC6 Express card
2
notch
3
clip
4
plastic standoff tab
1
2
3
4
book.book Page 104 Thursday, August 13, 2009 7:27 AM