Cisco 10000 - Manual (Page 115)

3-33
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 3 Configuring Remote Access to MPLS VPN
Configuration Examples for RA to MPLS VPN
router ospf 200
log-adjacency-changes
auto-cost reference-bandwidth 10000
network 10.1.1.1 0.0.0.0 area 40
network 172.16.0.0 0.255.255.255 area 40
!
!Configures BGP to advertise the networks for each VPN.
router bgp 100
bgp router-id 10.1.1.1
no bgp default ipv4-unicast
bgp cluster-id 671154433
bgp log-neighbor-changes
bgp bestpath scan-time 30
bgp scan-time 30
neighbor 10.1.1.4 remote-as 100
neighbor 10.1.1.4 update-source Loopback0
neighbor 10.1.1.4 activate
!
!Enters address family configuration mode to configure the VRF routing table on BGP.
address-family ipv4 vrf vpn1
redistribute connected
no auto-summary
no synchronization
exit-address-family
!
!Configures MP-IBGP.
address-family vpnv4
neighbor 10.1.1.4 activate
neighbor 10.1.1.4 send-community both
exit-address-family
!
!Specifies the IP local pool to use for the vpn1 VRF address assignment.
ip local pool vpn1 192.168.1.1 192.168.2.67
!
!Enters routing information in the routing table.
ip classless
ip route 192.168.16.0 255.255.255.0 198.168.76.1
no ip http server
ip pim bidir-enable
!
!
no cdp run
!Configures RADIUS accounting. radius-server retransmit is on by default and cannot be
removed.
radius-server retransmit 3
radius-server authorization permit missing Service-Type
call admission limit 90
!