Cisco 10000 - Manual (Page 510)

A-6
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Appendix A RADIUS Attributes
Vendor-Proprietary RADIUS Attributes
163 FR-DTE-N392 Not Applicable
164 FR-DCE-N393 Not Applicable
165 FR-DTE-N393 Not Applicable
166 FR-T391 Not Applicable
167 FR-T392 Not Applicable
168 Bridge-Address Not Applicable
169 TS-Idle-Limit Not Applicable
170 TS-Idle-Mode Not Applicable
171 DBA-Monitor Not Applicable
172 Base-Channel-Count Not Applicable
173 Minimum-Channels Not Applicable
174 IPX-Route Not Applicable
175 FT1-Caller Not Applicable
176 Backup Not Applicable
177 Call-Type Not Applicable
178 Group Not Applicable
179 FR-DLCI Not Applicable
180 FR-Profile-Name Not Applicable
181 Ara-PW Not Applicable
182 IPX-Node-Addr Not Applicable
183 Home-Agent-IP-Addr Not Applicable
184 Home-Agent-Password Not Applicable
185 Home-Network-Name Not Applicable
186 Home-Agent-UDP-Port Not Applicable
187 Multilink-ID Multilink is not supported.
188 Num-In-Multilink Multilink is not supported.
189 First-Dest Not Applicable
190 Pre-Input-Octets Not Supported
191 Pre-Output-Octets Not Supported
192 Pre-Input-Packets Not Supported
193 Pre-Output-Packets Not Supported
194 Maximum-Time Typically not used in DSL environment
195 Disconnect-Cause Supported and tested
196 Connect-Progress Supported and tested
197 Data-Rate Typically not used in DSL environment
198 PreSession-Time Typically not used in DSL environment
Table A-2 Vendor-Proprietary RADIUS Attributes (continued)
Number Vendor-Proprietary Attribute Status