Restrictions for implementing ipv6 vpn over mpls – Cisco 10000 User Manual
Page 141
4-9
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 4 Configuring Multiprotocol Label Switching
IPv6 VPN over MPLS
Restrictions for Implementing IPv6 VPN over MPLS
The 6VPE feature has the following restrictions:
•
6VPE is supported by an MPLS IPv4-signaled core. An MPLS IPv6-signaled core is not supported.
•
The maximum number of IPv6 VRF's that can be supported is 2038, including the global routing
instance. However, out of 2038 VRF’s, only 1200 eBGP sessions are supported; the remaining
VRF’s are to be static routed.
•
The maximum number of routes supported across all IPv6 VRFs, including the global routing
instance, is 50,000, which yields approximately 24 routes/VRF.
Configuration Tasks for Implementing IPv6 VPN over MPLS
Tip
The 12.2(33)SRB release introduced the Implementing IPv6 VPN over MPLS (6VPE) feature. As a basic
reference to this feature, see the Implementing IPv6 Addressing and Basic Connectivity chapter in the
Cisco IOS IPv6 Configuration Library at:
The IPv6VPN over MPLS (6VPE) includes the configuration tasks in the following list. For more
information about these tasks, see the Implementing IPv6 VPN over MPLS (6VPE) chapter in the Cisco
IOS IPv6 Configuration Guide, Release 12.2SR at:
•
Configuring a Virtual Routing and Forwarding Instance for IPv6
•
Binding a VRF to an Interface
•
Configuring a Static Route for PE-to-CE-Routing
•
Configuring eBGP PE-to-CE Routing Sessions
•
Configuring the IPv6 VPN Address Family for iBGP
•
Configuring Route Reflectors for Improved Scalability
•
Configuring Internet Access
Note
Cisco 10000 series routers do not support the mpls ipv6 vrf command that has been listed as one
of the steps to configure VRF for IPv6.
The IPv6VPN over MPLS (6VPE) feature also supports the configuration of the following features on
Cisco 10000 series routers:
•
•
IPv6 Internet Access, page 4-11
•
VRF-Aware Router Applications, page 4-12
•
•