Cisco 10000 - Manual (Page 512)

A-8
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Appendix A RADIUS Attributes
Vendor-Specific RADIUS IETF Attributes
Vendor-Specific RADIUS IETF Attributes
234 Target-Util Not Supported
235 Maximum-Channels Not Supported
236 Inc-Channel-Count Not Supported
237 Dec-Channel-Count Not Supported
238 Seconds-of-History Not Supported
239 History-Weigh-type Not Supported
240 Add-Seconds Not Supported
241 Remove-Seconds Not Supported
242 Data-Filter Supported and tested
243 Call-Filter Not Supported
244 Idle-Limit Not Supported
245 Preempt-Limit Not Applicable
246 Callback Not Applicable
247 Data-Svc Not Applicable
248 Force-56 Not Applicable
249 Billing Number Not Applicable
250 Call-By-Call Not Applicable
251 Transit-Number Not Applicable
252 Host-Info Not Applicable
253 PPP-Address Not Applicable
254 MPP-Idle-Percent Not Applicable
255 Xmit-Rate Typically not used in DSL
environment.
Table A-3 Vendor-Specific RADIUS IETF Attributes
Number
Vendor-Specific
Company Code Sub-Type
Number
Attribute Status
MS-CHAP Attributes
26 311 1 MSCHAP-Response Not Supported
26 311 11 MSCHAP-Challenge Not Supported
VPDN Attributes
26 9 1 12tp-busy-disconnect Supported in Cisco IOS but
not tested on the
Cisco 10000 series router.
Table A-2 Vendor-Proprietary RADIUS Attributes (continued)
Number Vendor-Proprietary Attribute Status