Clarion UNGO MS3001 - Manual (Page 17)

MS3001 / MS3200 Installation Manual - Page 15
Valet Mode
Allows you to temporarily disable the security system when the car is being serviced or turned
over to a parking attendant.
To turn Valet Mode on or off:
1. Turn on the ignition.
2. Press and hold the override switch.
3. While holding the override switch, turn off the ignition.
• The siren will chirp once to indicate you have turned Valet Mode on.
• The siren will chirp twice to indicate you have turned Valet Mode off.
4. Release the override switch.
While Valet Mode is on, you can continue to lock and unlock you doors with the Remote
Transmitters, as well as operate the Auxiliary Functions.
For added protection, when the doors are locked by the Remote Transmitter, the system’s Starter
Disable circuit will activate and the LED will emit double flashes until the system is unlocked by
the Remote.
If the Remote Transmitter is lost, stolen, or becomes inoperable while the car is locked in Valet
Mode, you can use the
Emergency Override procedure to deactivate the Starter Disable circuit.
On Disarming, if the system responds with one long chirp and one short chirp, indicating the
system was triggered, the LED will flash for 60 seconds to indicate the zone that triggered the
system.
LED Flashes (60 seconds):
1 flash = door
2 flashes = Shock Sensor
3 flashes = optional sensor
4 flashes = hood/trunk
example: flash-flash-pause-flash-flash-pause = Shock Sensor
Tamper Alert
install_MS3001.qxd 8/11/99 4:15 PM Page 15