Cisco WIRELESS-G WBP54G User Manual

Page 12

Advertising
background image

7

Chapter 4: Setting Up and Connecting the Wireless-G Bridge for Phone Adapters
Starting the Setup Wizard

Wireless-G Bridge for Phone Adapters

Chapter 4: Setting Up and Connecting the Wireless-G
Bridge for Phone Adapters

To configure the Bridge, run the Setup Wizard on the CD enclosed with the Bridge. This chapter and the Setup
Wizard will guide you through the installation procedure.

Starting the Setup Wizard

To begin the setup process, insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup Wizard should
run automatically, and the Welcome screen should appear. If it does not, click the Start button and choose Run.
In the field that appears, enter D:\setup.exe (if “D” is the letter of your CD-ROM drive).

On the Welcome screen, you have the following choices:

Click Here to Start or Setup - Click the Click Here to Start or Setup button to begin the software installation
process.

User Guide - Click the User Guide button to open this User Guide.

Exit - Click Exit to exit the Setup Wizard.

Running the Setup Wizard

1. To install the Bridge, click the Click Here to Start button on the Welcome screen.

2. After reading the License Agreement, click Next if you agree and want to continue the installation, or click

Cancel to end the installation.

Figure 4-1: Welcome Screen

Figure 4-2: License Agreement Screen

IMPORTANT: Do not connect the Bridge until you are instructed to do
so or the setup will not work.

Advertising