RadioPopper PX - Manual (Page 21)

P1 Clone Mode
RadioPopper PX Radio Wireless System
Page 21
Your PX Transmitter and PX Receiver units provide a feature which allows backward compatibility with RadioPopper P1
Transmitter and P1 Receiver units. In this mode, your PX unit essentially “clones” a P1 unit. In other words, your PX will
behave exactly as if it were a P1 unit. The PX actually runs the exact same software program as the current model P1’s.
In P1 mode, many of the enhanced features of the new PX radio system are disabled. You may only have one device
actively transmitting in a given area and the PX unit will not trigger JrX receiver units. Additionally, it should be noted
the P1 uses a slightly different type of radio signaling which is limited power by legal FCC requirements. Thus in this
mode, you will observe shorter operational range than in the normal (“non-P1”) PX operating modes.
Please refer to the RadioPopper P1 Owner’s manual for a full description of operation in this mode as all features are
identical except where noted below.
You may download the P1 Owner’s manual online by visiting radiopopper.com/manuals or at the direct link:
http://radiopopper.com/docs/radiopopper_p1_manual.pdf
P1 Menu Mode
To re-enter the menu system from P1 mode, press and hold both “X” and “P” buttons together. The menu will then
display your current battery level. Cycle through your menu until you see “P” or “P1” and modify that to a channel
value.
On a PX Transmitter you will know you are in P1 Mode if you see a solid green LED and a solid yellow LED. On a PX
Receiver you will only see the green LED slowly blinking.
Setting P1 Mode
To enter “P1 Clone” mode, adjust the Radio Channel in the normal PX mode to “P1” (which follows “16”, then loops back
to normal radio channel “01”. Any time the CH menu displays “P1”, the unit is in P1 Clone mode.
Note in P1 Clone mode, some of the usual PX only menu items will not display.
Sync Interval Select - (S) - Cloned P1 Transmitter Only
You will also note in P1 mode, an additional menu item, the “S” menu will appear on the Transmitter only. This menu
sets the Sync Interval as described on page 20 of the P1 Owner’s Manual.
To adjust the Sync Interval, tap the “X” button to cycle through settings 0 through 9. Setting 0 actually corresponds to
setting “10” on actual P1 units, which would normally be indicated by 10 blinks of the yellow LED.