RearviewSafety RVS-091407 - Manual (Page 9)

10
Installation Guide
Installation
Take the Wireless Transmitter and using the double sided 3M
Sticker attach the box to the inside of your car.
Replace the light socket back into the reverse light housing.
Replace any interior panels that may have been removed to
access the taillight and close your trunk or
rear hatch.
Put the vehicle in reverse. If you have a clear picture, put the
vehicle back in park and turn the key to the off position. You are
now ready for fi nal stepshousing.
10.
8.
11.
9.
.
6.
Plug the attached wire from the Camera into the Wireless
Transmitter. Ensure that the wires are not tangled.
While sitting in the driver’s seat of the car with the key in the
ignition position. The monitor will automatically start when
vehicle is put in reverse. If when you place the vehicle in
reverse there is no image, you may need to pair the camera
with the monitor
7.