Crestron electronic Isys G-Series TPS-15G-QM - Manual (Page 34)

Isys ® G-Series Touchpanels Crestron TPS-12G/15G/17G-QM
Ethernet Setup Menu
Touching the Ethernet button on the SETUP MENU displays the ETHERNET
SETUP MENU. This menu provides information on the Current IP Address and
Ethernet link status, along with buttons for DHCP Enable and Disable and, when
DHCP is disabled, Static IP Options.
The enable/disable Ethernet feature is provided on the INTERFACE MENU.
Ethernet settings are made through Crestron Toolbox. Refer to the TCP/IP
Communications section of “Establishing Communication”, which starts on page 56
for additional Ethernet setup details.
Touch Ethernet Status Test for details such as the IP Address, Subnet Mask,
Default Router, IP Table, etc.
The ETHERNET SETUP MENU also provides – and + controls to set the CTP Port.
Touch Set Default Port to return the CTP Port setting to its factory default.
Touch Return to go back to the SETUP MENU.
ETHERNET SETUP MENU (DHCP Enabled)
To use a static IP address, touch DHCP Disable. The ETHERNET SETUP MENU
will change to show the Static IP Options.
30 • Isys ® G-Series Touchpanels: TPS-12G/15G/17G-QM Operations Guide – DOC. 6415B