Crestron electronic Isys G-Series TPS-15G-QM - Manual (Page 51)

Crestron TPS-12G/15G/17G-QM Isys ® G-Series Touchpanels
NOTE: Crestron recommends an independent power supply for the touchpanel.
QM-TX QuickMedia Transmitter
The QM-TX QuickMedia Transmitter can be used to connect a video or audio source
to a QuickMedia network without a locally available QM transmitter (such as the
QM-WMC).
The QM-TX accepts composite video, S-video, component video, RGBHV and
audio signals. These signals are encoded and converted to the QuickMedia standard
and fed over a CAT5E or CAT6 cable to a QM receiver (such as the
TPS-12G/15G/17G-QM). All signal routing occurs automatically under the
command of the control system.
For more information, refer to the latest version of the QM-TX Operations Guide
(Doc. 6334).
Cable Management
The TPS-12G/15G/17G-QM uses a built-in strain relief to prevent the accidental
disconnection of vital cables and provides strain-relief for connectors on the cables
and the touchpanel. Refer to the following illustration to use the built-in strain relief
mechanism to secure cables to the touchpanel.
TPS-12G/15G/17G-QM Cable Management
Remove the four
cover screws to
access the I/O panel
Route I/O cables
through these valleys
Use the screws and metal
brackets to clamp the I/O
cables in place
Operations Guide – DOC. 6415B Isys ® G-Series Touchpanels: TPS-12G/15G/17G-QM • 47