Tomei Powered HICASS LOCK II TYPE B - Manual (Page 17)

LEFT SIDE (THEN RIGHT SIDE) SHIM INSTALLATION
Page 5 contains the opposite sides clearance for the Shims.
●Vehicle "Self-Diagnostics", move the power cylinder.
Self-Diagnostics.... What HICAS moves and how to verify the job.
・When changing your steering wheel boss, check to make sure it's the HICAS compatible type.
If it's not compatible, then change the steering wheel to the stock standard one to get it working.
・This is done with 2 people, 1 at the steering wheel, and the other working with the Shims.
・Install a Shim on one side, then if there's enough gap to insert the shim on the other side,
then you won't need to do this.
For vehicles equipped with HICAS II
① Remove the Solenoid Valve Connector.
Connector Color: Brown
Pin : 2 Pole
② Start the Engine.
③ Turn the steering wheel full lock to the side
where you had installed the shim
The cylinder will move and the gap will widen
The cylinder will move and the gap will widen
on the other side.
※As shown on the illustration on page 16,
you install the shim on the right side first.
Then you can make the gap wider with the
steering wheel.
④ Separate the Shims to install them in place.
⑤ Use the screws to secure the shims in place.
17
Full Lock
Shim
Open
Shim
Screw
Screw
Cylinder