Installation verification, Wheel alignment – Tomei Powered HICASS LOCK II TYPE B User Manual
Page 19
INSTALLATION VERIFICATION
① Re-install the power cylinder.
② Turn off the engine.
③ Fix in place by using both wrenches to tighten
both nuts.
④ Fit the boots over the shim, and tie in place with the large
cable tie.
CAUTION
Wh
i
th b
t
bl
t t
l t
id ith
Correct
Clearance
Contact
Screw
Shim
Nut
Adjust and position the shim so that the nut will not cover the screws on the shims.
When covering the boots, use a blunt tool to aid with
positioning the boot in place.
Take care not to damage or tear the boots.
⑤ Safely lower the vehicle.
WHEEL ALIGNMENT
If you install a shim HICAS lock, your toe settings will be affected.
Correction to your toe settings will be required to correct your steering alignment, this
will prevent uneven wear on your tires.
The amount of toe-in will have changed due to the installation of the shims.
A professional wheel alignment will correct this.
Toe-in = Heel Gap-Toe Gap
19