Tomei Powered HICASS LOCK II TYPE B - Manual (Page 18)

VEHICLES WITH SUPER HICAS
① Have the engine turned off and the gear in neutral (AT cars in P). Have the Handbrake/E Brake on.
② Then position the steering wheel to the center.
③ Perform the following operations within the first 10seconds after the engine starts
(1) Start the engine
(2) Turn the steering wheel from side to side, at least "5 times each side", turning the steering wheel
at least at 20 degrees.
(3) Turn the steering wheel 5 times as shown below, and then Pump the brake (at least 5 times) afterwards.
Please be sure to perform in the order as shown.
【STEERING】 【BRAKE】
5 times each for both left and right. (At least 20 degrees) Step on the pedal 5 times.
④ Raise the engine rpm above 2000rpm.
Left Right
Turn at least 20 degrees on each side.
①
②
③
④
⑤
①
②
③
④
⑤
⑥
⑤ Turn the steering wheel more than 180 degrees to
install a Shim. Allow movement of the rear open
side. This gap does not require a Shim.
※As shown on the illustration on page 16,
you install the shim on the right side first.
Then you can make the gap wider with the
steering wheel.
⑥ Separate the Shims to install them.
⑦ Use the screws to secure it in place once fitted.
18
Turn at least 180
Shim
Open
Shim
Screw
Screw
Cylinder